Related Products

Fluke 345 Power Quality Clamp Meter

FLUKE 345 Power Quality Clamp Meter 
  • Verify batteries: Direct measurement of dc ripple (%) for battery and dc systems
  • Troubleshoot harmonics: Analyze and log harmonics digitally or graphically
  • Inrush current: Capture and analyze nuisance tripping,from 3 seconds to 300 seconds

Product Details

FLUKE 345 Power Quality Clamp Meter

This clamp on meter is a combination power analyzer, power quality logger, and clamp meter, and is ideal for monitoring electronic loads.
With the bright color power meter display to analyze the harmonic spectrum, a low-pass filter to remove high frequency noise, and a high EMC immunity design, the Fluke 345 power analyzer is ideal for troubleshooting power quality on switching loads. Additionally, the Hall Effect clamp meter design makes measurement of dc current possible without the need to break the circuit with the power meter. The internal memory of the power analyzer enables long-term power quality logging for analysis of trends or intermittent problems.

Applications
Setup and troubleshoot variable frequency drives and UPS systems - Verify correct operation by measuring key power quality parameters. Harmonics measurements - Uncover harmonic issues that can damage or disrupt critical equipment. Inrush capture - Check start-up current where spurious resets or nuisance circuit breaker tripping occurs. Load studies - Verify electrical system capacity before adding loads.

AC/DC current: Clamp-on measurement of ac current up to 1400 A rms and dc current up to 2000 A without breaking the circuit. Highest safety rating: 600 V CAT IV power analyzer is rated for use at the service entrance. Accurate in noisy environments: Clamp meter performs even with distorted waveforms present on electronic loads with low-pass filter.

Data logging: Identify intermittent faults by logging any power quality parameter for minutes, or over a month, including harmonics. Verify batteries: Direct measurement of dc ripple (%) for battery and dc systems. Troubleshoot harmonics: Analyze and log harmonics digitally or graphically. Inrush current: Capture and analyze nuisance tripping, from 3 seconds to 300 seconds. Easy to use: Easily confirm power meter setup with large backlit color display of waveforms and trends. 3-Phase power: Built in capability for balanced loads. View graphs and generate reports: Use power analyzer with included Power Log software

Power Standards Lab CTE1 Current Transformer Ethernet Interface Module A compact combination of the ETH1 Ethernet Module, and the XCT5 Current Transformer Interface Module. Adds Ethernet ...
ELSPEC Multi-Frequency 3.5G Wireless Modem The SCM-0001-000 wireless GPRS Modem provides fast mobile communication access and offers the perfect solution in industrial data communication....
AUD $ 750.00 ex GST
Power Standards Lab ETH1 Ethernet Module PQube Plug-in Modules and Accessories Connect your PQube via Ethernet Module to access PQube data remotely from anywhere in the world, using an...
Power Standards Lab PQube AC Power Monitor Three-phase and single-phase monitoring up to 690V, 50/60Hz. Power Quality monitoring : - Voltage dips, swells, and interruptions - wavefo...
ELSPEC G4100 Display Unit. The Elspec G4100 Remote Display LCD Unit is an integral part of the Elspec Power Quality Data Center system, allowing interconnectivity with the G4400 series instr...